Dynosty's awesome gauge for the SW20, replaces factory clock.

The final production version will be 4 digit gauge displaying in red. That will allow for a CLOCK!! and 7 other displays for:

- E85 content
- Boost pressure
- Water temp
- Oil pressure
- Air fuel
- Air temp
- Voltmeter

VIDEO DEMO

For the switching between displays, there will be a remote wire (that can be used for a remote push button switch), and there will be an on-board switch, which will work with the left clock button.

The board will have a couple very small connectors on it, and we'll provide the mating plugs with 12" pigtails on it. One of the connectors will be 6-pin for 12V, Gnd, Lights, 5V Out (for sensors that require it), Remote Switch and one reserved for future use. Another connector will be multi-pin for the sensor inputs.

For installation you will remove your clock assembly and take the factory board out and replace it with our new board. You then can drill a tiny hole in the back cover of the clock assembly to feed the wires through.

Sensor Pricing:

(no support for any sensor not supplied by Dynosty)

E85 Flex Fuel Sensor $199
Boost Pressure $39
1/8 NPT Water Temp $18
1/8 NPT Oil Pressure $29
Air Fuel (calibrated 0-5v = 10-20 for Haltech)
3/8 NPT Air Temp $28
Voltmeter (read off input wire)

The clock display will be separated with a decimal point instead of a colon. Examples below

12.00 vs 12:00
1.45 vs 1:45
2.11 vs 2:11

The price of these gauges will be $199 + $15 shipping (to continental US) and however many sensors you want to monitor.

To buy the gauge go to http://www.mr2oc.com/showthread.php?t=514978